Before you connect to internet, you have to add four components in your computer, they are Dial up networking, Dial up adapter card, TCP/IP protocol, (This and finally you have to add modem driver. Please follow the following instruction to setup modem driver.

1. Double click My Computer, then double Click Control Panel, and then double click modem icon, then you will see a picture as follow:

2.  Please select "Don't detect my modem; I will select it form a list.

3. Please select "Have Disk..."

3. Press "Browse" button to locate the modem driver path as if you are not install it from Driver A:\ .

4. The computer will found out a suitable modem driver then press "Next"

5.  Select a Communication port for the modem, COM1 or COM2 is for external modem, COM3 or COM4 is for internet modem, don't select "Printer Port (LPT1). Press "Next", a new modem driver will be added.

6.  If you are using Voice modem, then you will be prompt to add "Wave device for Voice Modem"

7.  Same as above, press "Other Locations" you have to locate where is modem driver put in. (The same location of modem driver)

8.  Then you will need to select country, please select Hong Kong, then Next.

9.  Then give a name to this connection "NETfront V.90"

10.  Please enter the telephone no. be "30013579"

10.  Then click "Next" and "Finish" a new dial up connection icon will be created.

11.  Double click "NETfront V.90" Icon, and enter your username and password and click dial, a connection will be established.